in pieces when gate opening in more than 10% of the axial force of the gate Industrial Valves, gate valve operating torque changed little. When the gate opening is lower than 10%, due to the throttle fluid, increased the gate valve pressure difference before and after. The differential pressure effect on the disc, the valve lever larger axial force is needed to drive the gate, so in this range, the operation of the valve torque change is larger. Flexible disc gate valves, close to closing the required operating torque is bigger than the rigid disc. Gate is closed, because of the sealing surface sealing way is different, can produce different situations. For automatic seal gate valves ( Including flat gate valve) In the valve is closed, the sealing surface of the disc is right for valve seat sealing surface, is a gate in the full open position. But this position under the condition of valve operation is unable to monitor, so in actual use, is the gate to dead point position as the gate valve seated position. Thus, automatic sealing gate location is fitted according to the location of the damper ( The trip) To determine. For mandatory seal gate valves, closed must be make the ram pressure to the valve seat. The pressure can ensure the sealing surface between disc and seat sealing strictly, is forced to seal gate valve sealing force. The sealing force due to stem nut with self-locking will continue to do. Obviously, in order to provide sealing force to ram, stem nut transmission torque than the torque in the process of valve operation. Thus, for mandatory seal gate valves, seated position by the stem nut torque size to determine. Gate Industrial Valves is turned off, because the media or the change of environmental temperature, thermal expansion of the gate valve parts can make the pressure between disc and seat, reflect on the stem nut, for the open gate difficult again. So, open the gate Industrial Valves torque than shutoff gate valves required torque required, in addition, for a pair of sealing surface contact each other, the static friction coefficient is larger than the kinetic friction coefficient between them, to make them from static state to produce relative motion, to exert greater force to overcome the static friction force. Due to changes in temperature, pressure, between the sealing surface to overcome the static friction force is bigger, so that the open gate, the torque exerted on the stem nut sometimes will increase a lot.

gate valve torque reference table (nominal diameter mm） Nominal pressure ( MPa） 0. 250. 61. 01. 62. 54. 6. 410. 016. 020. 032. 0 moment ( N· m） 50252550505010010020020020020065255050505010020020030045060080505050801002002003004506009001005050100200200300300450600100012001255050200200300300450500900－－150501002003003004505006001000－－200100200300300450500600100012001800－25010020030045060060010001200－2500－30020030045050060090012001800－－－35030030050075090012001800－－－－4003004506001000120018002500－－－－450450450100012001800－5000－－－－500450600120018002500－5000－－－－6005009001800－3500－6500－－－－70060012001800－5000－8000－－－－80090012002500－8000－－－－－－900100018002500－－－－－－－－1000120018002500－－－－－－－－1200180025003500－－－－－－－－1400250035005000－－－－－－－－

For the study, researchers defined Mech Valve as strategies to foster some social good, including programs that benefit community engagement, diversity, the environment, human rights and employee relations.
As manufacturers we are determined to be the very best in flow control valve, regardless of the size, pedigree or inclinations of our competitors.
Once we have a good idea of how wedge valve can satisfy customer’s needs, consider whether we should create a skill for their demands.
There are many advantages associated with .