1 pneumatic butterfly valve, flanged butterfly valve before installation check no missing parts, each part model is correct, check valve body without sundry, solenoid valve and the muffler internal nonblocking 2, the valve and cylinder are placed in the closed position. 3, will hit the valve cylinder, The installation direction parallel to the valve body or vertical) , see if the screw hole for again, won't have too big deviation, if you have a little deviation, cylinder block turning point, then tighten the screw. 4, after the installation of debugging pneumatic butterfly valve ( Under normal circumstances gas supply pressure is zero. 4 to 0. 6MPa） Debugging operation manual operation with solenoid valve opening and closing ( The solenoid valve coil manual operation shall be effective after losing electricity And observe the pneumatic butterfly valve opening and closing. If in the process of debugging operation found some difficulty in opening and closing process of the initial valve, after normal, you may need to dispatch cylinder stroke ( The ends of cylinder stroke adjusting screw to adjust a bit at the same time, adjust the need to run the valve in the open position, and then dispatch air off again) Until the valve opening and closing action smooth and closed without any leakage. Also it is important to note that the adjustable type silencer can adjust the valve opening and closing speed, but not too small, otherwise may cause the valve is not action. 5, have to send before installation should keep dry, not 6 in open air, the butterfly valve to check the pipeline before installation, make sure that the pipe without welding slag and other foreign bodies 7 hand-operated, butterfly valve body resistance is moderate, butterfly valve torque matching with the selected actuator torque. 8, butterfly valve connected with the flange specifications correctly, pipe flanges are in conformity with standard butterfly valve flange to the clamp. It is recommended to use special butterfly valve flange, flat welding flange shall be used. 9, confirm the flange welding is correct, not welding flange butterfly Industrial Valves after the installation, so as not to burn rubber parts. 10 and the pipe flange are going to have to pack good, and with butterfly valve in the. 11 and install all flange bolts, with the hand tight, just, will confirm the butterfly valve with flange and with the opening and closing butterfly valve, to ensure that the opening and closing flexible. 12, the valve fully open, tighten bolts, using a wrench, in accordance with the diagonal order without washers, never will bolt screw tight, in case caused serious deformation, valve ring opening and closing torque is too big.
The use of resilient seated valve double flanged gate valve is a great trend in today's world. What you should know is that it has become a very important part of business today.
Many websites provide additional information on the topic of flow control valve. One such site worth visiting is Mech Valve.
Shenzhen Mech Valve Trading Co., Ltd. offer various lines of products in line with international standards along with professionals who can offer suitable solutions pertaining to the existing problem in os&y valve wedge gate valve.
We afford not only the best product but also the comprehensive service, satisfy the customer's demands.